Looks like that's the way I may be headed. My buddy is bringing over his Snap On scanner to check for codes. I don't know if it will show anything. I had the same problem with the French doc. Although it looked as if he removed the relay and reinstalled with clean solider. The rest is a mystery. Bat...

Remember, 1) "people posting failures bias" as well as 2) careless do-it-yourselfers using the wrong fluid PLUS 3) people performing fluid refreshments well into their transmissions' sickness and 4) myths formed back in the early days of automatic units where the gunk actually did help sea...

Yes, see post above. Problem is in the board level of CEM.

Relays are electromechanical switches. Heavy wires run from the 12 volt supply to the relay to the loads. Very little current is needed to turn the relay itself on and off. So you can run a heavy wire (say 10-12 gauge) from battery + through a fuse and through a relay to your load(s). You then run a...