Crystal oscillators usually generating clock signal. There is some different shapes and forms but will give hint mostly if this is an issue. If you keep meter open try use finger on the clock oscillator if it starts working.

Hello, I got the 850 OBD app and a dual PCB PIC18F based ELM adapter, I'm wondering if these "BUS INIT" errors are due to bad ELM or car issue, I'm trying to figure out why my guage cluster isn't working. Some functions work totally fine (module scanning and clearing seems to work fine) b...

If you end up opening the gauge cluster there is at top left "Yazaki" chip it might need reflow soldering as even it not being the brain OBD might still affected by it too as the K line chip (or actually just some totally not K line com chip which been used as one as Volvo did during this ...

Last night i finally cracked the code. And no its not anyway shape similar to VGLA process. They encrypted PIN better than alarm box so roughly two weeks right after work hours while being high on sugar to figure it out step by step progress until today now we are here and tested and ready to publis...

Dude thats CDM. So its CAN Bus. You have 1999.

Dude thats CDM. So its CAN Bus. You have 1999. :wink: If this is the case then previous owner must have swapped the cluster in from a 99, how does one tell the difference between 98 and 99 cluster? This car is certainly a 98, it has no key chip immobilizer and the vin is 98 also. MCU and other thin...

9168144 is just plastic..

In middle plastic at the bottom has a label

Its not 'just read' in that memory chip so you need do little exercise.. just post it (memory).

Edit: read it as 24C01