MALL240 wrote: ↑31 Jan 2020, 09:30 Fixed, thanks. Can be closed.

Someone may come along in the future with the same problem. Posting the fix would be appreciated.

Short and sweet, beautifully explained. If only all car DIY videos were this good...

Mumbai Figured Out A Brutal Way To Deal With All Those Idiots Who Honk At Red Lights I’m not sure how much time you’ve spent hanging around with traffic lights, but if you have, you know that they really, really do not give a shit what you think. That’s why if you’re at a red light, honking is usele...

Did my inner and outer tie rods and sway bar links. I found out that if you take both your end links off other sway bar swings up and makes it pretty difficult to get back on. I also struggled alot with getting the new boot over the inner tie rod.. not sure if I even got it all the way on.. After I ...

1991 240 runs very rich at low speeds. Cold start injector leaking, or ECU's temp sensor AWOL. With the control unit connected , connect a voltmeter across LH ECU terminals 13 and 5 (ground) for Bosch LH 2.4 systems or terminals 2 and 5 (ground) for LH 2.2 systems. This unit is in the passenger sid...

Junkyard find of a 1990 740 wagon

https://www.thetruthaboutcars.com/2020/ ... 000-miles/

That's a lot of miles.

-A

Well, not today, but this last weekend I: Pulled the droopy sagging headliner out of my wagon in preparation for replacing it with the un-saggy one that's been taking up room in my garage for the last couple o' years. Dropped the sunroof assembly to try and fix it so it would slide all the way back....

rhstrickland wrote: ↑11 Feb 2020, 19:56Engine races at startup

Like this?

Done engine mounts on my '98 V90 couple years ago , decided to choose " Corteco " brand after reading some forum thread stated that " Corteco " brand was OEM from factory. No issues about using product so far. Used this online references as example : https://www.volvoclub.org.uk/...

If both sides are off the ground then the sway bar will not need to be pried. That happens when one side is not at the same position as the other a that when the sway bar gets twisted. The threaded ends use locking nuts. The ends of the threaded studs should have Torx in them to use to hold the stud...