All set

I think one of the things is to have the hole is such way, so as not have the oil from the filter leaking onto the plate - this will cause the oil to run on the top of the plate and drip at some other place. Maybe look here

I thought about it too but decided to leave it alone. To do it "properly", you need to cut 2 openings: 1. A round opening for the oil filter area. 2. A rectangular hole for the oil drain plug area. Seriously, removing the 6 or 7 10-mm bolts is not that bad, it takes about 2-3 minutes. Tric...

Agree, with an electric drill+socket, the plate is out in no time - we get used with removing it