During a long (and ultimately doomed) restoration of a 1998 v70 GLT (story for another time, or never) I did a complete rear end rebuild and found myself searching in vain for replacement rear brake dust shield gaskets, so I thought I would post my DIY cut files here to make someone else's life easi...

Never worked on the back end more than replacing brake pads. Based on the effort required to get to these is it worth it to pull the shields and gasket from a salvage yard? Getting the rear dust shields off requires removing the wheel bearing... so you're looking at pulling the wheel-> caliper -> r...

Same code, similar issue for my 2007 xc70. Slightly rough idle and ECM-6140 after doing a timing and PCV job. Spent hours triple checking timing (and confirmed via cam adaption angle in vida), replaced both VVT Solenoids, only to discover an old cracked and corroded pigtail by the connector. IMG_101...

Ah nevermind! Discovered the glossary. Reset valve camshaft, intake / exhaust (CA) Measurement range: 0-100% The pulse ratio transmitted by the engine control module (ECM) to control the camshaft reset valve. The value indicates control of the camshaft reset valve to control the camshaft position (a...

My 257k 2007 xc70 suffered a uniquely stupid form of engine failure last week. TL;DR injector failure caused misfires, a smoking tailpipe, a flooded cylinder, and compression failure in three cylinders. Backstory Fuel economy suddenly dropping in the last month (down to sub 14mpg in city driving fro...