Have you tested the ASA parts in Texas weather?

How about direct UV exposure?
volvolugnut

I've dabbled in 3d parts for my own cars but I haven't made the jump to ASA yet. I know its better for UV resistance and high temps. But I'm think bigger parts than emblems or lock pins.

It's great that you're offering replacements for such old cars. Consider creating new parts for common problems, like a stopper for the center console arm rest hinge to prevent it from over extending backward and snapping the weak stopper in the console plastic. I've been working around that failure...

Things that come to mind would be any and all interior trim pieces, I designed a replacement for the inner door handle housing several years ago. I bet it would go better in ASA now. Door cards would interesting. The holy grail of interior parts will always be with the dash board. The piece of the d...

Seriously, after 13 years of driving 850ies I still have no Idea where to put my phone while driving. I usually put it under the parking brake, but this isn't good for spirited driving. Under the armrest I have my wallet. And the tiny compartment on the driver's door is full with who knows what. Tha...

Proclipusa used to make one that attached to the right side of the centered area. It wedged itself between the dash pad and the dashboard and did not block any vents. I don't see it available anymore. I used to have one years ago. Here are some pictures i stole from Google. BR.851936.jpg BR.851936-1...

I use magnetic ones that clamps on the vents in all my cars, the V70 and the Subie have thick enough vents to support them. The 940 however has thin ones (similar to an 850iirc), which eventually broke off. To avoid breaking them again when I replaced the vent, i made a small 3d printed support to r...

Be careful when you do this. The repair has to be thin as the 4 mounts sit in a cupped section on the dash. The thin plates do minimal lifting on the dash mounts so don't affect how it sits. Unfortunately I don't have a car to take a picture of to show it. I am still hoping to get this completed thi...

Nice! Don’t forget the frame on the third rear seat pop out stick that’s also NLA