I'm not sure I follow fully here so is that the green connector your referring too for cockpit-2? And its pin 17 for that connector? And Yes please the pinout for the barrel would be extremely handy. Sorry for the delay, I wasn't at home. Do you have the P1 CEM ? If yes, everything is written on th...

Yes, it is :

Hi, I have made my own SBL in C for the P1 CEM ref 31327215, it is working well, I'm able to read the complete flash including eeprom, erase sectors and write to it. I tried it on an other CEM (still P1) 30765015 but it seems that asking the checksum using the CAN protocol doesn't work, on the 31327...

Hi all, like I said previously, I share with you my work on SBL for P1. With this software running on raspberry Pi and a dual CAN board I was able to dump (EEPROM and Flash) the CEM on High Speed and Low Speed CAN bus line and also the DIM on both on bench and in car. I was able to flash eeprom and ...

Oh ... at least 2 month working on it by night when my child is sleeping... That's also why I'm sharing it, making win time to people who need it. I understand ! Have you made a SBL for the SH7055 ?

Very nice project! would it be possible to share the SBL for the DENSO ? I did a similar thing on old Fenix 1B (Renault 2L Turbo ECU that I put into a Clio RSi with a mercedes compressor added to the engine) that was based on 68HC12 MCU, I finally was able to rebuild on paper the complete formula fo...