TY, ordered. Any idea what their lead time is like? When they first came out, it was a couple weeks as they were made to order at the time. Looking at the website now, it appears like they may be a stocked item, but I can't confirm. They're usually good about reaching out after an item is ordered i...

Thank you again. Is there a good dual exhaust cat back that isn't obnoxious available for my car or is custom the way to go? The 2000 R had a factory dual exhaust that's great - assuming you can find one these days, which is essentially impossible. There are no currently produced AWD dual exhaust s...

I have re-used many times. Don't recall ever using Loctite, but for piece of mind you could use a little blue Loctite. Warning is that they are hard to undo in the first place, so adding thread locker may make it really hard in the future should you have to remove the prop-shaft again. Check page 13...

can anyone confirm that the rear driveshaft bolts to diff torque spec is 26 ft lbs then 90 degree turn? Are these bolts reusable or one time use? Red loctite or just torque? One time use. New ones come with new loctite pre applied. I’ve re-used them, but it’s not advisable because they a) like to s...

You guys/gals are going to get tired of all of my questions lol. I would like to replace the front and rear brakes, rotors and front soft brake lines. What do you recommend? The brakes currently work but rear brakes are thin and I would rather not risk failure of the soft lines on the road and star...

TY. These are the parts I already ordered. Some have made it here and some will be here this week. I think I pretty much followed your recommendation except maybe the upgrade jkit https://i.imgur.com/OUBtHff.png https://i.imgur.com/jU7SGiF.png https://i.imgur.com/n995WHd.png https://i.imgur.com/IaE...

Like all thinks on cars, there are different opinions. I have reused the prop-shaft bolts multiple times with no issues. The one thing I check is the hex head is not damaged. If it is I do not re-use them. These bolts are not torque to yield. The first torque is to seat the flange square. 2nd is to ...

If you are going VOLVO OEM I would buy them today.

OEM are made by Rotunds in India, and they have a 50% tariff target on their back this week.

Like all thinks on cars, there are different opinions. I have reused the prop-shaft bolts multiple times with no issues. The one thing I check is the hex head is not damaged. If it is I do not re-use them. These bolts are not torque to yield. The first torque is to seat the flange square. 2nd is to...

Quick wipe down and vacuum of the interior. Not as bad as I thought although from the seat fabric it looks like the po owned a pet raccoon, or one made it its home when it was in the field https://i.imgur.com/Sxb6oAr.jpg https://i.imgur.com/m4tmwUW.jpg Looks fantastic! Cleaned up nice given how lon...