I think you mean rebuild the ECU?

It's quite a bit more than simply rebuilding the ECU but https://www.vasttuning.com or DIY e.g. viewtopic.php?t=88302

It's color is sort of burgundy, same as one of mine so I can get the paint code off mine if anyone wants it. It's picked pretty clean, but most of the body panels seem clean, though the rear doors are missing bolt on trim. Dash is clean, including the pad. I didn't pay much attention to the interior...

I think this method will work on all years of 240 Volvo sedans. It is based on the method used to open my 1987 244. If your trunk is full of luggage or boxes, you will not be able to access the lock. My trunk would not open and I did not seem to have any key that would fit the trunk. I may never hav...

I have the US model turbocharged 3.0 liter that comes in the R-Design model of the 2013 XC60 . The pan should work for all 3 engines according to Volvo. It also fit 2013 S80 and looks to be very generic so should install pretty straight forward if you don't have many other parts in the way. May be ...

Originally, Volvo recommended inspecting or replacing airbags after 10 years (extended in 2003 to 15 or 20 years depending on model year). Per Service Manager Bulletin 88-017 in 2006, airbag lifetime has been extended to "the lifetime of the car". Does that mean the airbags will work? Mayb...

I dont know about P80s, but my 1994 940 airbags were working in 2022

Source: my face

I've recently seen a 1993 240, 1993 850 and 1994 850 with bags deployed properly, as well as a 2000 S70 with SIPSbags and the main airbags deployed. I trust them more than any Takata airbag! My 1994 has a sticker in the door jam for 2004, 1998 for 2008, and 2004 for 2014 - but Volvo apparently exten...

Hello everyone! As shown in the What did you do to your Volvo today?-Thread I have designed a repair patch for the center tab of the dashboard kickpanel on the drivers side. What is the Issue? The mounting tab where the kickpanel is held in place by a torx screw breaks/crumbles off and the screw has...

Catless 3" downpipe for P80 cars with straight flange turbos ('93-'98). Will not fit 99+ or AWD cars. It's mandrel bent 304 stainless steel, with one O2 sensor bung and a v-band flange - you will need to add a v-band flange to your existing exhaust to run it. Brand new, only took it out of the ...

The accelerator position will usually come up on the list of faults, however I have never replaced an accelerator position sensor after working on quite afew of these early ETM cars. So many errors on these ETMs apart from the position sensors. In the pile of discarded ETMs I accumulated over the ye...