Quick question for any DIY folks... Is there a way to short across the analyzer port station on center console to make the "engine light" blink the code number of what is wrong? Did this on '86 S10 I owned...paper clip from Pin A to Pin Z and then turn to Acc give two blinks then start co...

Long time since I looked at this, but if I recall there were several things on the same circuit. I can't recall but I think there were 3 things. The barometric sensor, the (can't recall the name) sensor on the front cross member and I thin the 3rd was some sensor on the A/C system near the bulkhead...

They say not to use an impact driver on those tools... I run a drill bit through the plastic bushing sleeve on the top of the bushing. https://turbochuckcom.ipage.com/webimages/projects/97%20Volvo%20855/2019susp/ihaveyounow.jpg It allows the shell to break away from the arm. Also, it leaves no melte...

I was referring on gray one when someone said that they are born bad.
It seems that someones experience is that grey one should be replaced with green.

I'm using a blue one. It's only like 8lbs or 12lbs or something like that. But green is the correct one.

I believe that it’s the IR sensor
for the optional remote control.

I do not have any dead locks but I've read a few other threads and maybe this will work https://www.digikey.ca/en/products/detail/cantherm/STS110003CHIP/6201878 The only issue is the rather moderate resistance at normal operating conditions which is roughly 500 at 25 C. Alternatively, you could just...

IIRC, there was an improvement in the changer mechanism, but the thing that I was after was the “hidden menu” that gave access to a user tunable EQ. Setting the custom equalizer (Custom EQ) - SC-901 only · Select "Custom EQ" by switching off the radio, holding down preset button 2 and swit...

Hey abscate, can you add a picture of the location of the offending article if you have a chance? For the life of me I can't picture what bolt you are talking about and where it fits. Thanks for the great info. Appreciate you taking the time to document this kind of stuff for us. Neil. Heres a pict...