Can you sand the edge of the seatbelt slot to remove any rough surface? Another option would be to use some of the 'U' shaped plastic that is used to save door or panel edges from chipping and fit it between the panel and the seat belt. Neil. . Since you asked I had to take a closer look :roll:. It...

Corrected above. 1998is not CANBUS

I actually bought a used clockspring off ebay that guaranteed to work and I tried to center it and still same message. Using icarsoft to reset it would not reset the Steering angle. Kept saying failed. Two of the other 3 sensors it did reset but still same message. I am buying a new steering angle s...

I sure forgot how nice an m56 is in slippery icy conditions. By controlling torque precisely she was easy to get out of the deep pack driveway. Got all the cars out, blew the 18 inch of white over to the edges, got full width of the three x two car driveway so everyone can get in and out. All on onl...

My volume knob broke off so I 3d printed a replacement. It took 3 tries to get the fitment correct but it works perfect now.

No really, it’s right there.

Did you have the repair done under your name? If so, why was it not covered? I was not happy when my V70R Xemodex rebuilt ABS module started to play up to find like vehicle batteries, only the original purchaser was covered, even though the item was only 3 years old and had a 'lifetime; warranty. N...

Had the alignment checked yesterday and the problem became very obvious, All numbers were within spec except the left rear wheel. It was found to be toed out about 1/2 inch and a little too much negative camber. Toeing it in reduced the camber slightly to bring it within the allowable range (rear ca...

It might offend thee but these radios sell for $25 on eBay

Mine is a '99, which had the flashing arrow and check engine light. When I scanned it, I got TCM-0039, which is "Gear shift position sensor Faulty signal". I figured might as well start by cleaning the PNP. I found this thread...https://www.matthewsvolvosite.com/forums/viewtopic.php?t=2993...