Any B5254T2 engine would work. It was used in S60, V70, S80 and XC90. No model year compatibility issue, no ECU coding required. On top of other routine checks&updates, like PCV and t-belt, I would advise replacing the rear main seal and exhaust manifold gaskets/studs while the engine is out. It...

It might be worth dropping the pan and just swapping in a new bearing shell? Maybe only 6 hours of labor. Cylinder head and valve cover lobes have some significant wear even w/o oil starvation. Running without oil wrecked both for sure. Oil starved 5 cylinder is good maybe for weights or fancy glas...

urosm wrote: ↑02 Jun 2022, 15:03 CEM PIN is: 15 52 29 21 65 26

Third byte (shuffled) should be 65, and it was indistinguishable in the very first pass and got filtered out. You can email me your dump, I may find time to load it into my CEM and try with my cracker, which seems to work fine in cases when others fail.

Hello to all! I tried to crack CEM from the 2012 Volvo XC90, but I cannot for some reason. Tried with OBD and on the bench. Same result. Also, I tried different shuffles, but without success. So here are the logs if you find a problem, please fix it. Here's your pin compare routine disassembled. Ba...

oscilloscope wrote: ↑03 Jun 2022, 13:38 is codewarriror used too decompile the micro's ?

https://onlinedisassembler.com/odaweb/

Is there a shuffle order? No, but endianness is different (do bswap_16). Wrote this to aid the brick CEM cracking. #include <stdio.h> #include <sys/types.h> #include <sys/stat.h> #include <fcntl.h> #include <unistd.h> #include <assert.h> int main(int argc, char *argv[]) { int ifd = open(argv[1], O_...

You have to remove alarm in cem config and after - disconnect siren. If you have cem flash, send it to me, i'll remove alarm from config ( in case if you do not know, how to do it ;) ) Oh, also, also... Maybe internet wisdom knows at least where to start looking at... I'm planning upgrading my tire...

My exhaust VVT hub failed (started to leak) at around 220k miles. You may have another 50k miles. Or not.

In any case, you may want a new O-ring, fcpeuro sells it for $9.99.

Burnt exhaust valve most likely. I'd say, it's about same labor, down or up. Much easier if you do it on a car lift, in that case you can lower the whole subframe. Up: https://a.d-cd.net/8755455s-960.jpg Clearance was real tight, I needed a load leveler badly, since you have to dance transmission ar...

Will not cause any issues (besides that Bosch rebuild can fail sooner than you expect).