Send me a pm if you want, just like SAS DIODES


thread here

viewtopic.php?f=1&t=78410&p=582194#p582194

Status sep 2021, parts on order

It’s one Imperial inch for that height limit

Raise engine:
Raise engine max 30 mm. Use jack tool No. 998 5972, or equivalent.
Remove two engine mount bolts and slacken the third bolt.
WARNING: The inner, left constant velocity joint will be damaged if the engine is raised by more than 30 mm .

It’s not rocket science but you do need a good machinists square..basically a piece of milled steel that is proof straight. I’ve long since valued a machine shop cost over my solvent, cleaning cost, and foobarring the warp measureent though. My local shop charges $25 to dip , clean , and measure a h...

Old guy advice. You want primary reference information on a big thing like this, not sifting through3 facts in 97 posts of untruth. Link to volvo web store https://www.volvopartswebstore.com/showAssembly.aspx?ukey_assembly=236700&ukey_make=865&ukey_model=12011&modelYear=1998&ukey_cat...

Nautic Blue
Is a special Hue
It’s cool for school
And all the other kids drool

There is some sort of copper alloy in the engine mount which seizes and grips those bolts like the Devil. I threw my ezouts into a lake years ago, after the last of many snapped off hardened steel extractors in problem bolts. I’ll find and post the diagram of the mount you need to remove, I’m pretty...

Late thanks for the nice documentation of the delta link tool anvil abovr

Here is the go-to site for part numbers...you will need your VIN to get the right engine mount number

https://www.volvopartswebstore.com/cars ... parts.html

I’ve got the early 1998 engine mount spare, I think

volvolugnut wrote: ↑12 Sep 2021, 14:04 OK. You have to explain these creatures to a land locked Okie.

volvolugnut

https://en.m.wikipedia.org/wiki/Horseshoe_crab

Spray paint with LiquidSteel (tm) and you are done!