nice job!

My guess is the mirror assembly needs to come off to do this right- https://www.youtube.com/watch?v=GuohKS6u6tY , then you should be able to gently pop the temp sensor plate out (refer to the tabs on the new part for guidance). Photos show the new part with crimped connector pins, if you don't have ...

Previously uncrackable CEM: CPU Maximum Frequency: 600000000 CPU Frequency: 600000000 Execution Rate: 600 cycles/us PIN bytes to measure: 3 Number of samples: 30 CAN low-speed init done. Reading part number from ECU 0x40 on CAN_LS CAN_LS ---> ID=000ffffe data=cb 40 b9 f0 00 00 00 00 CAN_LS ---> ID=0...

If you have a matching car and Dice-206751?

PM me to get software for a try and report back to the forum...

At the moment i give hints to get the code by pm or someone else uploads it here, i won't do that...

If you don't want to fall the cem asleep and run it in a diagnostic session you need power on pin 8 and 15.

Here, who has 6 byte code, CEM from MY2006- and DICE-206751 absoloutly FREE...
Reads your cems complete flash in a few seconds...

https://filetransfer.io/data-package/bsTYjdGO#link

.. high up sh*t cut ... How about people here already made their financial future, well, secured, because they have their day job, which pays some competitive money? There's always a high demand for brains outta here, right? Trying to monetize this niche project for niche car versus working for alm...

Vollmer Making a GUI is always a longer route than command-line, and remote projects between people who have never met are always more difficult because of project management/goals/timezone/native language, etc. I've been involved in software since the 90s, and GUI is a whole can of worms for design...

Sorry was 50 downloads only, here are both again...

Also Windows 10 doesn't notice me about anything, maybe it is location based on 3 computers i get nothing. Maybe defender in US sees something problematic in this code...