Here is my write-up for removing the oil pan, or oil sump as some call it, in order to remove and replace failing o-rings throughout the lubrication system. Removing the oil pan for o-ring replacement is a messy affair, but very necessary if you are experiencing low oil pressure due to old and degra...

1995 Volvo 850 A/C SYSTEM SPECIFICATIONS Compressor Type .................... Zexel DKS-15CH 6-cyl. Compressor Oil Capacity ..................... (2) 6.8 ozs. Refrigerant Capacity (R-134a) .................. 26.4 ozs. High Side ............... 406-450 psi (28.5-31.6 kg/cm ) Low Side ...................

This is great!

I have been thinking about adding storage drawers and a simple fold out kitchenette for camping trips. I would like to be able to install or deinstall within 10 minutes and will design it so that it will fit underneath the rolling cover that covers the cargo area. Will probably get this done sometim...

edited

I like the list order. Although if the ball joints are super loose, that is a safety issue you can't have those failing on the road. Visibly, horribly loose ball joints leap frog to the top of the list. Volvo brand reman axles are probably A-OK. I've never seen it posted about to pop off the PTC pla...

The oil cooler lines on these cars are known for leaking where the rubber hose is crimped to the metal ends. Mine have been leaking for about 4 years, but it was a slow leak. Today I decided to repair them. The Volvo replacements are a steep $250 for the pair. There are aftermarket brands but the re...

**************************************************** volvo850diag v0.9 is now available! **************************************************** There is a new volvo850diag v0.9 version (dated 2019-07-14) available for download as: https://jonesrh.info/volvo850/volvo850diag.zip It's the first update i...

Found a perfect fender panel in the junkyard Monday. Does anyone know how to install the outer door trim? Does it just snap onto the plastic pieces or is it better to slide it on? Are you referring to the plastic trim that runs along the lower side? That should just snap into place, there are clips...

That front seal is the hard to find/ expensive part.

1/4 the cost of a new compressor