740 Intertiment Starting Problem Topic is solved

watchdog · Post by **watchdog** » 21 Jan 2004, 08:58

Hi:

Thanks for any input you are willing to provide

A.Baker · Post by **A.Baker** » 22 Jan 2004, 08:54

I just bought an 87 740t and the previous owner had the same concern. He switched to high test fuel and the problem went away. I on the other hand am CHEEP and bought regular gas and now I have a no start after a 10 min. or less hot soak. The turbo has been removed so heat from that is not the cause.

Good luck.
A. Baker

Guest · Post by **Guest** » 23 Mar 2005, 15:41

hello there i had that problem it's one or two things check your motor fly wheel just had mine replace because some times it started and sometimes it didn't also i had a bad computer which also was replaced good luck

A.Baker · Post by **A.Baker** » 25 Mar 2005, 10:07

The problem you are haveing sound like the one I had. At the end of all the testing I found that the sensor below the intake manifold between #3 and 4 was bad. That sensor tells the the computer it the car what temp. the engine is. and adjusts the fuel/air mix accordingly. I also found that the ecm under the r/side kick panel had some dammaged pins that were easy to clean. Hope this helps.
A.Baker