Forgot, all the expert advise and credit to those who came before us. Much respect!
http://cleanflametrap.com/oilpan/

20200627_212123.jpg Hey just wanted to close out for "Historical record" Completed, recovered, corroded, eroded, clogged, blocked, broke, and busted PCV, Oil return, Flame trap, Oil pan, Oil Pump, Oil Pump Sump, Oil sump screen, Oil leak, ok enough tags. 240 Oil change? LMAO😎 20200701_153652.jpg ...

Thank you! That's the piece that's missing from almost every PCV issue forum, YouTube, even the Haynes manual. Be well, good luck with the sale.

No worries, I think your good brother! I took pics hope it gives you peice of mind. I think your good to go, clear your conscious, it's all good. That "bracket" I moved with a flat tip, slipped that doglegged "pipe" with the "tab" at 12:00(front bumper 12 o'clock, driver side 9, psngr 3, rear end 6 ...

Good to go. I believe the "channel" the pipe is guided thru is the 1st 4 inches is the only thing inside the block thus the dogleg in the pipe. I'll be making a post of my lil adventure. Working condition are all low budget and DIY here, but I have the time tho... 6am and my garage is already over ...

Is this the same as what you're working with?

20200627_212123.jpg
Hello forum mates,

I am trying to reinstall a missing PCV oil drip hose that fell into the oil pan... I already disengaged the oil pan and fished the old hose out of there, now I have the new one and because of the lip or flange I can only think it goes from top-down, but ...

Sergitin32

Hey, Rick here with what may be the same issue. I've opted for the drop the motor mounts/crossmember/rack & pinion, and built a engine bay lift from channel iron.
I've cycled the engine oil thru nylon 5 times to remove what was left of the corroded, errodide, crumbling 27 yr old "oil ...

Tach for sale?

Ricky.j.peterson@gmail

93 240 SW 5SP, Snowflake switch failure? I know the compressor is shot, not cooling when cycling, but regarless the bulb stopped illuminating when selected to on position, compressor cycles intermittently, not shim worthy so I removed washer shimms, again I know I need a rebuild/replace clutch, BUT ...