Engine coolant sensor replaced. No difference.

Replaced MAF again. Same Denco:
P0113
P0102
P0011 NEW!

Cleared codes took a little ride. So far it's much better. Doesn't stall while stopping. But there are little vibration and car slows down a bit quickly when I let it roll without pushing gas.

No vacuum leaks, no exhaust problems, throttle body is good.

It looks like it's still MAF sensor. Which one should I get now?

This one
https://www.eeuroparts.com/Parts/76270/ ... r-1976020/

Not sure, but exhaust looks and smells fine.
So, going back through all suggestions:
1 Vacuum Leak
2 throttle body
3 Computer

So far Temperature sensor replaced. Issue is still there.
Not sure it doesn't make a sense to replace fuel filter. Car eats gas well and doesn't stall when MAF is unplugged. Too well. Like 14mpg.

I probably going to check it for vacuum leaks at repair shop tomorrow and if it will not do I'm on the ...

Ordered temp sensor and fuel filter. Thanks for all the troubleshooting and advises!

is that what I need?
https://www.ipdusa.com/products/7090/Th ... 699-115567

or just sensor?

Shouldn't it show P0118 if this sensor is bad?

Yes. I love the vehicle too.
But it looks like I initially bought it with this problem.

I do not have VIDA/DiCE can I go around?
Are other cars like Honda and Toyota as demanding as Volvos?

I've always believed in Sweden though I feel like I'm in Denmark

Not stalling while idling.
freeze frame:
SHRTFT1 -3.1
LONGFT1 -0.8