Hello.

Today my car died at parking lot, I wasn't able to start it.
It was starting, and then die after 2 seconds.

Lately I also had problem with fluctuating rpm and stuff.

So I towed it back home with my brother car.

Tip, always check if you have a towing hook at the trunk, I bought my car ...

Hello
Here is the link with pump noise.



I received odb scanner, but apps like torque pro and car scanner does not show any readings about fuel pressure.

Is it possible, that without fuel pressure sensor, I will not be able to read it with cheap odb scanner?

Regards

Thank you guys for peace of mind, timing job with dual vvt is not in my technical skills range yet.
Garage just did it 5k miles back and it was a bit expensive.

About symptoms I wrote, today I received odb scanner, and problem is with camshaft sensor or wires.

Appreciate your help.

Cheers.

Thank you Gentleman's, timing job with dual vvt is not in my technical skills range yet.
Garage just did it 5k miles back and it was a bit expensive.

About symptoms I wrote, today I received odb scanner, and problem is with camshaft sensor or wires.

Apriciatte your help.

Cheers.

Hello

I was replacing rear camshaft exhaust seal in my '06 2.0t V70.

After job was done, I have cleaned outside housing, and accidently also my marks, and when I was tightening cam sensor positioner I snugged m10 screw, and tighten it a bit more. After that I tried to back it up a little, but with ...

Hey, I can upload video tomorrow, also I will have fuel pressure readings.

During this job, timing belt, water pump, tensioner was changed, all engine seals including vvt seals, cam seal, camshaft seals and whole pcv system were replaced.
Also etm was cleaned.

I have a new conclusion about the topic.

1 one is problem with whining started after mechanic did a big job with all engine seals and pcv system.

Maybe fuel line in engine compartment is bend somewhere?

Second one, is that I bought injector rings, and they were also changed during the job ...

Hello.

Appreciate your suggestion.

Getting a bit desperate, today after driving through a big puddle, after few miles when I get home, and tried to park, car started weaving rpms from 500 up to 1500, and stalled a bit.
After a moment it stopped.

Then I was looking for pem module, in wheel arches ...

Hey.

Thanks for trying to help, I can see your quesses are very accurate, I already checked fuel lines, nothing is bend or broken.

New pump is whole unit.

About this pem, it is strange, because I couldn't find it under rear left passenger seat.
Did a little research in past about it location, but ...

Hello.

I was trying to find pem module, as I thought the same, unfortunately no luck.
It is not in the trunk, next to spare wheel and also couldn't see it at top of plastic tank.
But I still think it should have pem module right?

About the fuel line between tank parts.
Do you think it would bend ...