Should I design my own con or should I just use a breadboard?

If you look at the board in this link : https://www.waveshare.com/sn65hvd230-can-board.htm You can see there is a small 10 k resistor on the board next to the chip on the side of the board, at the top were the screws are there is a jumper which connect the 120 k resistor which is used if you ...

This one should have the can side of the components if i am not mistaken
https://www.waveshare.com/sn65hvd230-can-board.htm

Goodluck :)


So, with these, I don’t need the resistors


If you look at the board in this link : https://www.waveshare.com/sn65hvd230-can-board.htm You can see ...

Good evening.
I have been for a cheap but effective way to unlock my cem pin through the obd2 port
I found the teensy 4.0 method but I'm having a hard time finding parts.
I found a pcb file which has all the wiring for the pcb as well.
However, I cannot find the bosch cf160 transceivers needed ...

Good evening.
I have been for a cheap but effective way to unlock my cem pin through the obd2 port
I found the teensy 4.0 method but I'm having a hard time finding parts.
I found a pcb file which has all the wiring for the pcb as well.
However, I cannot find the bosch cf160 transceivers needed for ...

Yes it is all original

So, I have had the message "BULB FAILURE PARKING LIGHT" for a few years now, but only just got to looking into it.
So, I removed the headlights and found that the bulbs were burned out on both sides.
I ordered 2 new bulbs, fitted them, and I still have the message on my dashboard.
I can confirm, the ...