You’re the first person here to ever run out of gas. sincei ran out in the Kat When replacing the fuel pump, the drivers side of the fuel tank under the float was filled to the brim. The passenger side did look low. After replacing the pump I did jack up the drivers side of the car to attempt to tr...

Posting my foolishness for those that may come looking in the future. It just needed some gas. 🥲 So, the fuel pump gets power for about 1 second at key on, and then gets power again during cranking. I confirmed I had power during a crank cycle. Added 3 gallons of gas. And it fired up. I guess my fue...

ECM and TCM terminals are corrosion free and quite lovely, on both component and harness side.

lets review, New pump, it isn't pumping or priming. No power at pump terminals at key on or cranking. I'm still suspecting ecm terminals after an extended storage . You need the wiring diagram to trace the command wire from the ecm to the cem. If that circuit is good then the suspect is the cem. Co...

Your problem is not simple. It is hard for someone to follow along without making notes and seeing diagram. I doubt you will find answer here since someone will have to invest significant amount of time to figure it out. I see 2 possible ways moving ahead: 1) tow to the dealer and pay for diagnosti...

The fuel pump operates for about 5 seconds when the key is turned to position 3 and then it turns off. Have another person turn the key while you probe for pump voltage at the connector. I would also try starting spray just to verify that the spark and compression are still good. Just enough spray ...

Current fault codes: SRS: 007C and 0084 (rear seats removed to replace fuel pump) CEM: 1A57 RTI: E003 This car has already had Xemodex CEM service done in 2001. This car does not have a fuel pressure sensor on the fuel rail. The fuel pump recently developed a leak out of the top Flange. The plastic ...