Misha, that sounds like what is happening ....nearly exactly......I'll check the air filter tomorrow....its going be a cold night and it will be a good test for the whole system......by the way the CEL came on yesterday strong and set a P0455 code again......guess I am looking to the evap canister n...

Hey Misha....Check Engine is the faintly blinking/flickering....sometimes not at all...no orange arrow ....had the cluster out for the odometer gear fix a couple of months ago , think I broke the service light... Still no codes at all....drove it to and from work today...and I just touch the gas and...

Plugs out ...regapped.... not off by much if at all......but the car CEL is flickering even less and it goes really well....it's been a while since I had this kind of get up and go......Tomorrow I'll recheck the rotor and cap.....Looking better every day. Thanks everyone! Anything on the SAS Valve ?...

Ok, Now is it a serviceable part as in can it be taken apart and "cleaned" etc....or is it a part that just needs to be replaced?

Thanks....

Oh And I'll have all of the plugs out and regapped today....lets see if the flickering light goes away!

Thanks Misha!..I did use bosch replacements on the O2s....but checking the plugs once again is a good step...funny thing, they are platinums, and read somewhere else tonight I should take them out and go with OEMs ??? The elbow under the manifold had been previously replaced found that issue a while...

Ok Everyone, I think we have a good one here! My 189K 1996 850GLT NA started some funky stalling bit with no warning....I would be tooling right along and blub, blub and stall....set the CEL.... This could happen almost anywhere, but mostly after a little traffic. Sooo.... I did the usual, clean out...

I just had to replace the ECC motor in my dash and when I fininshed I realized my sunroof was open....when I completed the replacement and connected the battery the sunroof wouldn't close.....thanks to this thread I am saved....open and close the locking mechanism 3 times quickly with the remote res...

Ok, So it's been a little while , but I finally got the bars back on the glass....it was really tricky ...I had to do both sides at the same time....A bonus of this is that the glass mount torx screws were a bit loose which caused and airleak and now that is cleared up as well.... It took (11) 1 in ...

Ok, Sunroof is out ..not a big deal pull down the aprons on either side and four screws removes the glass....had a fun time with getting the glass to bend enough to get both bars on at the same time. Doing it one at a time only allowed the glass on the opposite side to bend enough to keep the new ep...

Ok all the epoxy is off and I have cleaned any residue of the stripper with mineral spirits. The bars have been repainted and I will remove the glass and re-attach the support bars this weekend..... Stipper used was a sprayable "Klean Strip Premium Sprayable Stripper" a quart with the spra...