I have 97 850 GLT & the AC works intermitantly (whenever it feels like it). I don't believe that it's the fan itself but possibly a switch or a control device of some kind. Does anyone have any ideas where to start my quest ?? Any pics re the fix would help - I'm a novice.

Thanks
Mikey

The big USGO Intake tube I am trying to replace looks like the one that is at the bottom pics in steve850's post.

I have a 1997 850GLT that I need to replace the USGO Intake Hose on (broken nipples). I have the part BUT it seems impossible to get to the bottom (other engine parts in the way). Is there a detailed repair walk thru that shows me step by step with pics how to accomplish this task ? This part is ...

The door will open but I have to roll down the window and reach out to pull the door handle. And I can open the door by doing this but it's getting to be a tiring habit.

THANKS !!

Mikey

One day I tried to get out of my 850 GLT just like I always do but the drivers side inside latch would not work. My best guess is that the latch assembly inside became detached. I tried to pry open the panel to take a looksee but alas I cannot get it off. Maybe there's a special place to start on ...

Another update to Emissions test: My 850 GLT on board computer now refuses to connect with the Emissions Testing computer. I have tried at 5 times allowing for reset time between each test. Does anyone have an idea what can be causing this ?? The local used parts guys want me to disconnect my ...

I just failed emissions. Codes were PO 116, PO 442 and PO 445. I've checked this forum for similar posts.

I just replaced the Alternator about 1 month ago and everything seemed fine at that time. The battery kept going dead.

Are these codes related to that event and if so, what do I need to do ...

Well, I finally have finished installing the new pads. I am busy writing a detailed instruction guide for noobs. It will have all the extra info that it necessary to complete the repair with pics. Hope to have it ready in about a week. Can't figure out which format to save it to and where to put it ...

I have a 1997 850 GLT that I am getting ready to change the brake pads on. I have downloaded the tutorial on how to proceed,however, I got to undoing the 7mm hexes and ran into a problem. The hex I used is with a bunch of other hexes that pull out. I could not get the hex to loosen the bolt that ...

I have a 1997 850GLT that is getting this reading also.

I went under the front end (below the Battery) & found a rectangular black canister.
I also looked back by the gas tank but there is nothing visible there.

The black canister had two vacuum-type hoses running from it which were small
in ...