Northeast CT. Hit a deer, took out hood, left fender, headlight, and grille. Radiator popped. Did not drive after. Looking to sell car as whole, not going to part out. Make offer, and if its more than the buy back from insurance we can work something out. Silver car. 188K on car, transmission rebuil...

still chasing the small evep leak...... any advice?

OK, New front sensor installed. Proper resistance on the heater circuit is 3 ohms, measured on the new one across the two center pins on the 6 pin plug. They are silver pins, the others are gold, on the OEM and new BOSCH from Rock auto at $80. Changing the front sensor from the top was a little diff...

Anyone know what the resistance should be for the heater?

Replacing the rear sensor did not fix the issue with the front sensor heater circuit, so I think they are either in parallel on the same circuit or have two separate circuits, which makes sense as the computer has to know the current in each loop to throw the code.

So I did the job today, you definitely can get a crows foot on there and a wobble extension in past the pipe, but I only had a 3/8" drive crows foot and I was afraid I would break the extension, the leverage on the sensor is minimal. So I dropped the exhaust, simple to do, pulled the heat shiel...

Make sure you buff the bellhousing and the block so when they go back together the car will start. Its free to do. Just want to make sure there is a good electrical connection between the engine/trans. While the transmission is of GM design, many of the internal parts are VOLVO specific and can not ...

So my rear 02 sensor needs to be replaced. I searched to see if there is a link on how its best done and didn't find one. There is a bolted joint in the exhaust right behind them and disconnecting there and removing the body cross braces might allow the pipes to drop if the flex up front moves enoug...

So My J hose is cracked, what a miserable place to put that canister. Took a few minutes under the car to find it. I think I will remove the the heat shield bolts for the rear muffler and try an get some extra clearance to work on the hose. The hose has two large cracks at the bend end where the cla...

Hello all, I have 6 Engine codes that set over the last 2 years, 3 are 02 sensor related. P0056 heated 02 sensor failure bnk 2 sensor 2. (this sensor cable is cut in half from dragging on the road after a stick pulled it down). New sensor on the way. P0156 02 sensor bank 2 sensor 2. Same issue. P005...