just a quick question: have you actually watched the heater control valve operating to make sure it's really working? My wife's 95 960 has slowly produced less heat over the last couple years. Today I finally took a look and determined that the control valve was not moving. Did I get all wonky and t...

very clean silver blue wagon, ex-diesel, with black leather seats and interior. fresh engine bearings and oil pump, mild cam, rebuilt R400 trans, World heads, Carter carb, new dist and alt,(all with less than 500 miles), IPD swaybars. passes oregon smog inspections. still ironing out some unfinished...

problem solved: tcm had lost its ground somewhere in the harness. ran new wire from pin to ground and system went back to normal.

swapped out tcm - same as before. will check obd unit as described. thanks.

my 95 960 does this and i was told to check for vacuum leaks in the climate control system, and the vacuum check valves. check to see if the car holds vacuum when accelerating the engine, as well as after the engine is shut off. this might only pertain to the 95 960 because everything got so complic...

not sure what you mean by "selector"? the actual gear selector? it's not locked. my primary problem is that i can't get any trans codes out of the unit. with a scan tool all i get is "communication failure". fluid level good, connectors at trans good, reverse lights good, soft cl...

led for port #1 (for the trans) does not go out or flash when i plug into it, just a steady glowing light. dash arrow on steady (no flashing). seems to be in winter mode with intermittent short bursts of downshifting into a "real" gear. tried replacing W-E-S switch to no avail. can't run a...