i like the look without the black, will the black vinyl pull off, or do i need some special equipment to remove?

after replacing the bearing plate on my original struts, i removed the struts i purchased from the salvage yard, reinstalled my original struts and took it for test drive at speeds up to 90 mph and no vibration, now i have no idea as to what would have caused the vibration, but it is gone and the ca...

I unbolted the strut at the bottom and tried to see if i could push the shaft inward, it did not move, also squeezed the inner boot to see if i could feel anything that may have come loose from the joint, did not feel anything so i put it back together,also tried holding the inner joint and moving t...

do i need to take the strut loose again to do this, how do i reseat it, turn the shat and push towards transmission?

i haven't checked them yet, but i will, think i'm going to also talk to a mechanic that i sometimes go to, thanks for the advise.

how hard is it to replace the axle shaft, is this something i can do myself, I've replaced one in the past, but that had bolts holding the axle to the shaft at the transmission, i don't see those bolts on my volvo

I replaced the front struts on my 2001 S80 t6, first did the right side, all went fine, then did the left side all seemed to go fine, but now when i accelerate, i get a severe vibration, that goes away as soon as i let off the accelerator, have removed the wheel and reinstalled thinking maybe that m...

good info, i substituted the rear fog light relay with the brake light relay, now i have brake lights and have never used the rear fog lights, so not missing anything there and no need to spend $20 for the new relay.

I have a 2001 S80, I have had that same squeaking noise for a couple months now, just looked yesterday and found out that the top strut mounting assemblies are bad,there are 2 pieces that make up this mount, mine the shaft of the strut pokes into the engine compartment when i push down on the front ...

I need to replace the front ball joints, can anyone tell me the procedure for doing this and are there any special tools required to replace the ball joints, i have done them on other cars, but these look different.