Does anyone know the process for rebuilding the MAP/Air Flow Sensor?

I am not about to pay these crazy prices and I see rebuilt ones for about 150. Why not do it myself I say.

K had belts checked. they are good. cutoff problem has not happened again. on way to have belts check, while there or back. Did disconnect map and the cut off problem duplicated itself so I know that. Replaced air filter. cleaned everything out. Had checked fluids and was fine. Oil was changed less ...

Found it and disconnected the cable. car would not start at all. I actually thought it may have been loose belts. Went and got them checked out. Car still does the no power thing. This morning it seemed like it was having trouble shifting. Once the car warmed up a bit it was good to go. I had checke...

where is the MAF sensor on 90 240

Ok here's the scenario: Everything was fine with the car ('90 240) running strong no problems. Got the oils changed and was told my belts were a bit worn. I figured better get them done sooner that later. After belts were changed start to hear squeaking/whining sound normally when the heat was on. I...

I've got a 90 240 with 4 speakers and stock cr-712 trying to install insignia cs102 got the harness (9pin) went to go install and am missing a few things I have a amp from the car but not on the new stereo i have a 2pin connector and nothing on the new stereo I also have the rear speaker wires on th...