Thats a good call, i will replace the rear O2 as well, then use some software on my laptop and clear the service engine light.

Could that be the indicator that comes on after x miles that tells us to take the car in for service? If thats the case, why would my scanner still puke the P0133 code?

rspi, i am new to the car, but i think that is exactly what i am talking about. What is the service light about? It's on for exactly 2.5 minutes every start.

I get a CEL for about 2 minutes every time the car is started. I checked the code and it's a P0133 (Sensor 1 Bank 1 O2 Sensor Circuit Slow Response). The code always goes away after about 2 minutes of operation. I figured i would just replace the front O2, i ordered a Bosch 15097 and installed the n...

My 2000 S80 recently went into limp mode, i read the codes and they reveal a ECM-902A, DTC is found not active. The local shop wants $1300 for replacement. Can i just pick up one of these units from the web and have them install it? Does it need to be re-programmed? Is it possible to just have mine ...

Thanks for that, it would look like it's a ECM902A - Signal Too High or Signal Missing, points to ETS / ECM wiring or module fail. I also read that this could be the MAF as well. I see others with the similar issue, but i don't seem many that post the result.

I have a 2000 S80, this car sat in a field for 3 years until about a month ago. Several parts were missing and seats were removed. I have managed to get the car all back together and have been driving it. I have driven 1.5 tanks of gas and now after the car is running for about 10 minutes it will st...

I recently got an 2000 S80, this car was previously stolen and much of the interior was stripped. At the same time the steering column was replaced. I have almost every thing put back together, however the turn signals and the high beams don't work. I tried pulling fuse #21 & #22, that did not f...

Did you ever get this done, i am about to do the same thing? Does the cover just pull off? Any issues with the air bag system?

I have a clicking noise when controls are pressed on driver side, nothing on passenger...