I am wondering if anyone on the board has a used Draper 69007 service light reset tool they would like to sell. I know they are discontinued, so just reaching out to anyone in the community that might have one for sale. Thanks!

I thought I would post this for any other folks who own a 97 850 and are dealing with a mysterious clicking sound when the front door hinge flexes.

After a lot of research I found posts talking about their being stress cracks around the spot welds that hold the flange that the door hinge bolts to ...

Hi! I am dealing with the same issue on my 97 850. Can anyone link me to photos, or a diagram. of what hoses to look for that may need replacing? I am new to looking for turbo lines and I don't know what to look for. Thanks!

In case anyone is curious this ended up being a bent dust shield next to the rotor on the driver's side axle that was scraping against the rotor occasionally - bent it back into position and no more noise.

Thanks, Ben850, I'll try that.

Thank you both for the replies. I'll check the motor- the control switch seems fine, but I'll check that, too.

I had not used my sunroof for a couple of months and went to use it last week but the front section is stuck. The glass will pivot up at the back to allow air flow, but it will not move down and retreat into the roof of the car to open the hole completely. Do these get stuck from lack of use? I ...

I went to use my windshield washers and the motor stuck on and would not turn off, even if I turned the engine and ignition completely off. I had to disconnect fuse #34. When I put it back in a day later the motor ran for a bit but turned off this time. Any suggestions on what I should check to fix ...

For anyone that's looking I just found a cheap new one on eBay. Should be good enough to last as long as I plan to keep the car:
http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... 0444058203

I had to repair a wire on my right front wheel sensor. Sensor now fixed and brakes perfect but ABS light still on and I don't have an ABS code scanner. Is there any way to clear the light without an ABS Code reader? Thanks!