Pulled into a gas station 80 miles into a road trip, tried starting the car again and it rolled over but never caught. Later found that I had no spark at plugs. Back tracked to check the distributor and cap and found no current coming from ignition module (is that the right term) there is fuel ...

I'm think I found out where it goes, still curious on what it is and the function.
On this picture I believe it is connecting to the 'canister' where it says from fuel tank in the bottom right corner. I'm hoping I can repair it wit a barb.

More info is always appreciated

its a softer/flexible hose

Hey folks. Trying to replace fuel pump by cutting out access panel. I accidentally cut a hose and I don't know what it is. In this picture I clipped the black hose that runs parallel with the green hose?

What hose is it? Can I fix with a repair kit?

Thanks

Hey folks. I am having some no starts while the engine is cranking over. I misplaced my spark plug wrench, Ill get one this afternoon. Anyways I thought it might be a fuel pump issue because I depressed the shrader valve on the fuel rail while a friend was turning the ignition. During this should I ...

Hey Lee thanks for the reply. all the fuses look intact that have to do with AC and temp control. I used a piece of wire and jumped the connections. An audible sound was heard as the compressor clutch engaged. I'm wondering if I have a leak in the system and a low pressure signal is stopping the ...

Hey guys. 98 v70 awd 2.4 Im having issues with my AC system. I first thought it was the relay, after replacing it, i'm not having any luck. When I use a jumper the ac compressor clutch engages and blows cold. What would be the cause of no signal activating the relay?

Thanks
R

The coolant was leaking a lot. Loosing a gallon over 35miles. Coolant smells like oil and the oil looks like chocolate milk. I thought it was having compression issues from the head gasket and from coolant/oil mixing. The last day it was running I saw water coming out from the back side of the block ...

Here are some more photos of it. I haven't been having any smoke. Not sure a valve job is necessary, I just already have the head off.

Thanks guys!

hey all, Just pulled the head from my wagon. I was expecting to see an obvious blow head gasket since there is coolant in the oil. I am wondering if just leaked around gasket.


Since I already have 1/2 the engine out of the car, the cylinders look in good condition. Would you recommend getting a ...