The car began to have same intermittent reduced engine performance fault codes.Finally changed the harness from throttle module to engine control module.So far,so good.Dealer quoted $2000 to replace harness and throttle body.Harness was $60 ,tool to remove ECM and TCM modules was $25.Took me 4 hrs.,...

Both axles and wheel hubs replaced,new angle gear coupling and transfer case,good used unit off of lower mileage vehicle.Mne was still functional but the splines were almost trashed after 196K miles

Glad to report that the vibration is finally resolved,it was the right side wheel hub or the right axle,Both parts seemed to be fine turning them by hand,all the vibration was felt on the drivers side under floor.Very humbling to have mis diagnosed problem and starting working on the opposite side.A...

I had a similar problem years ago,when hitting pothole right front tire.would get reduced engine performance.After much screwing around with new throttle pedals and new throttle bodies it always eventually came back.Problem was way too simple,on the fender there are a series of 10 mm bolts securing ...

I’m certain the axle is fully seated. Same vibration with new axle and bearing. I will replace the right side parts arrive Wednesday

neutral.ill change the right axle and wheel bearing and let you know

rotors and pads are new,calipers are not stuck,i cleaned and lubed the pins,they float freely and make no noise.I cant believe it would be the right front axle carrier bearing as it felt fine when i had it out but i will replace it anyway to rule that side out,then will be both axles and wheel hubs ...

I just had it up in the air all four wheels at thirty miles an hour indicated,cant find anything external,mounts are fine,carrier bearing looks a little tired but its not making noise.I ordered the right front axle and wheel bearing,they both look fine but thats the only thing left i havent replaced...

The noise begins as soon as i start driving,it just gets more noticeable,by thirty its a dull roar.Its not the axles or wheel bearings,makes no difference if im turning.Angle gear and collar just replaced but unfortunately had no effect.Its right under the drivers feet,basically where the axle goes ...

196k miles,Have two of these cars been maintaining them myself for 15 years now.I had the driver axle out with vehicle on stands and running,there was no vibration then at moderate wheel speed.I had the right side axle removed when i replaced the angle gear unit,the carrier bearing on right axle see...