For the head gasket it would go to the shop... $2500 plus. Engine swap I am pretty sure I can do myself. The motor that is in the vehicle I have no faith in as we have been chasing little things for 2 years. Why we are looking at just swapping motors. Either way a crap shoot.....but save $2000 with ...

Thanks all for the help! Pretty sure it's a headgasket. So.....here is the question. It's either do a valve job and replace headgasket (2500 + bucks) or just swap motors. Have the shop space, engine hoist, and have swapped motors on several old chevys, are there any secret hurdles or craziness if we...

Seems like car is sucking coolant through turbo. Other than blowing some steam it also steams/smokes off or exhaust manifold section between o2 sensor and turbo. started kindsasuddenly.......and motor otherwise runs fine. Does not seem to be a head gasket.....we are thinking there may be a seal in t...

Have a 2002 S60 2.4T that seems to be burning coolant through the turbo. If you pop the hood it cranes steam/ssmoke coming off of expose steel area between turbo and exhaust pipe (by o2 sensor) and it blows out smoke/steam out exhaust. Motor seems fine other and coolant is entering somewhere through...

All good stuff!! Many thanks, it has to be somewhere......just eliminate one thing at a time.

Has 118000 miles, and serviced consistently since we owned (since 05). Am a maintenence freak, lol.

After you run the car, and come to a stop or low idle and the no oil pressure warning light and warning message come on.....if you give it even a tad of gas message goes away???

Bad sending unit or sensor?????

Just changed oil and filter today.

Have completely replaced the cooling system, completely rebuilt turbo, cleaned turbo coolant lines, replaced crankcase vent hose and oil trap (pcv service by tech), and new thermostat housing gasket, inlet, and thermostat............problem is when I start it and let it idle......and when I place a ...

They just pull out, lol. Have o-ring connectors.....

Top metal tube that runs along heat shield.....connections is at top right......

Here is pic...of tip linr.