Login Register

Search found 7 matches

by weespoon
28 May 2016, 07:55
Forum: XC90 1st gen 2003-2014
Topic: Acceleration stutter + idle : MAF? Sparks? Injection/fuel filter?
Replies: 4
Views: 3668

Re: Acceleration stutter + idle : MAF? Sparks? Injection/fuel filter?

Is it still throwing the same code? The spark plugs are probably a fine thing to replace anyways, if it has been over a year since they have been replaced. Although it seems like I am more likely to get a miss under load with a bad plug. If you look at each plug as you pull it, it may give you more ...
by weespoon
28 May 2016, 07:37
Forum: XC90 1st gen 2003-2014
Topic: Brakes calipers are engaged when not pushing on brake pedal.
Replies: 1
Views: 862

Re: Brakes calipers are engaged when not pushing on brake pedal.

Worked on it some more, still an issue. The brakes work at first, pedal nice and high, minimal pressure to stop. After driving all brakes clamped. After driving, if I relieve pressure on DF all brakes release. All of these brakes (with exception of DR) were working correctly prior to main cylinder, ...
by weespoon
27 May 2016, 19:02
Forum: Volvo S40 & V40 2000-2004
Topic: V40 battery light and AC blows warm......
Replies: 2
Views: 1231

Re: V40 battery light and AC blows warm......

When you turn the AC on and off does the car change RPM when at idle? If not you may want to check voltage to your AC compressor clutch. If you are getting no change in voltage to your AC compressor clutch, and you have checked your fuses, then it could be the climate control module. I had a bad one...
by weespoon
27 May 2016, 18:37
Forum: XC90 1st gen 2003-2014
Topic: Is this "limp mode"? What's going on?
Replies: 5
Views: 7427

Re: Is this "limp mode"? What's going on?

Yes this does sound like electrical issues related to the sunroof drain as you suspect. The sunroof drain you can fix yourself. I would recommend simply hose clamping clear vinyl tubing near bottom of tube and running that outside instead of futzing with the part that gets clogged at the bottom. I t...
by weespoon
27 May 2016, 18:27
Forum: XC90 1st gen 2003-2014
Topic: volvo xc90 2.5t axle removal question
Replies: 2
Views: 1378

Re: volvo XC90 2.5t axle removal question

I recently did this job following instructions from this site. My approach strut compressor from loaner tool program at local chain auto store. Ratcheting strap 2" wide for control arm. A little heat applied to sleeve holding ball joint for removal. I would recommend this approach, trick is the...
by weespoon
27 May 2016, 09:49
Forum: S80 1st gen 1999-2006
Topic: S80 Heater core replacement
Replies: 46
Views: 40095

Re: S80 Heater core replacement

I had a very difficult time getting the clips back in as well. I second any one who mentions heat , as this is what finally worked for me. Here is what worked for me. 1. Most important put O ring in grove in housing not on pipe. 2. Put something slick on O ring (coolant works). 3. Very carefully sli...
by weespoon
27 May 2016, 09:11
Forum: XC90 1st gen 2003-2014
Topic: Brakes calipers are engaged when not pushing on brake pedal.
Replies: 1
Views: 862

Brakes calipers are engaged when not pushing on brake pedal.

Brakes calipers are engaged when not pushing on brake pedal. Synopsis: Replaced Master Cylinder, Brake Booster, ABS system, pressure bled, brakes appear engaged. More Detail: My brake pedal was fading to the floor, and the brake booster was hissing. I replaced the master cylinder and brake booster. ...