Hi, Over the years I've needed to clean or replace the MAF sensor multiple times, so, even though yours is only a few months old i'd start out by cleaning it. BTW I have have good luck with the Xmodex replacement etm, four years and 50,000 miles...

Just threw a new MAF sensor (2nd in 3 years), I Roll now purrs. Makes me think it would be a good idea to make a compendium of code concurrences (CCC), ie when it shows PDM-002B, ECM-680E, ECM-4801, ECM-1350 and PDM-002B it really means replace the MAF. Is there a secret decoder ring for I Roll?

the code reader, i think, has an E at the end (last letter doesn't quite fit on the screen). Found one reference to Turbo System Flow, anyone else run across this code? '01 xc70 runs rough for 10 seconds and dies unless I give it lots of gas.. also threw a PDM-002B code for a camera I don't have! bu...

I bought an ABS module for my '01 XC70 from Ebay, the only place that had the exact same module for less than what the car is worth...works fine

LOL, me too! The idea of removing everything was too much and winter is almost here!

mkc1 spot on! The gap was so large i'm amazed it worked at all! Thanks!

ahh, didn't think mechanical, I will go make it misbehave and watch the clutch, Thanks!

Hi all I have a venerable 2001 xc70 almost 200,000 miles on it, hopefully I can double that... So, Air Conditioner works fine until I have to stomp on it, or, if i have a load, mildly accelerate, Then it shuts off and will not come back on until I turn the car off and back on. I assume whatever rela...

Hi All,
Turns out the ABS module itself was bad and irreparable (i had sent it to Matt at Midwest Modules), I have a "new" one on the way, hope that does the trick! Thanks to all of of you for your help.

"bbbbrrrrppppp", eh?! reminds me of people making car sounds on the old Click and Clack, will give a listen once the bucket of bolts is back together.