Faulty DDM Drivers Door module. Fault: Intermittent low voltage output (@4volts)to window motor instead of 12v. VIDA shows switch carbon ... but shows button "activated" Fault code DDM 0005 signal low or missing Reflowed solder on output pins, no change. Checked voltage output pins ...

... battery first as it had been sitting for a while and had a battery low voltage warning on the DIM when purchased. Went ahead and did an oil change ... Passenger compartment temperature sensor - Signal too high/Signal missing CEM-9C03 Antenna/light ring - Signal missing REM-4F45 Parking assistance ...

... pressure circuit range/ performance P0107 P0642 Sensor reference voltage “A” low P0365 Camshaft position sensor B circuit bank 1 P0340 Camshaft ... cause it’s not Putting out enough voltage? Please help!!!! What am I missing?!

... the REM-1A05 code before. When I look that up it tells me the supply voltage relay (RMA1 in REM, 2/52, 15i rear feed) has signal missing or signal low, check for short circuit… I have yet to find a wire or connection that ...

... in the near future as well. Last thing I forgot to mention, I'll get a voltage low alert if I have the headlights on without the car running for ... Anyways, I wanted to cover my bases; feel free to tell me if I'm missing any vital information to help diagnose. Thanks for following along ...

... errors. Engine check light was on, so I tried it with my old Innova tester and it is still highlighting the P0016 cam/crank position sensor voltage error, and the O2 sensor voltage issue? So why is it reading the errors and not Vida? I reset them with the Innova and then took the car for ...

No misfires any more. Only valve issue is a recurring low voltage cam sensor message: P0016 or (643A) ECM-643A : Cam Position - exhaust: ... It was not until re-assembling that I discovered the pad retainer was missing (the owner had stripped that side and did not know there should be one). ...

... the cam position sensor due to an error code for cam sensor - low voltage: P0016 or (643A) ECM-643A : Cam Position - exhaust: Signal too low ... Fault ECM-531D : Malfunction indicator lamp (MIL) CEM: Signal missing (P0602) This seems to point at a checksum difference between the ...

... of the different modules. And your observation that there is voltage at the pump without it engaging is pretty clear. Those also all look ... disclaimer: I didn't read though this whole thread, so could easily be missing something important :)

... seen before: o2_sensors_at_CEL.png The sine wave on the rear O2 sensor voltage happened just when the CEL came on. It apparently stopped when I ... graphs: o2_sensors_manual_throttle.png Or am I missing something here? My guess is that the rear O2 sensor goes wacky after ...