IPD sale XeMODeX - Experts in Volvo Electronics Free shipping all USA - Experts in Brakes
Did you know? 🤔
Logged in users can get email notification of topic replies Log in or register (free).
Amazon Link Buy your stuff using this and it helps MVS!

"96 960- Anybody changed out the solenoids in the valve body

Help, Advice, Owners' Discussion and DIY Tutorials on all Volvo's "mid era" rear wheel drive Volvos.

1975 - 1993 240
1983 - 1992 740
1982 - 1991 760
1986 - 1991 780
1990 - 1998 940
1990 - 1998 960
1997 - 1998 V90/S90

dm635
Posts: 114
Joined: Wed Jan 16, 2008 9:46 pm
Year and Model:
Location: Lou. Ky.
Has thanked: 0
Been thanked: 7 times
dm635

"96 960- Anybody changed out the solenoids in the valve body

Post by dm635 » Tue Jan 07, 2020 11:46 am

History, installed a replacement transmission last summer from a car I drove 100 miles before pulling for mine. Felt good about it. After install I soon learned the pan was packed wit a couple inch's of very nasty sludge. Quickly followed by 4 or 5 filters and over 30 gallons of ATF doing drain and fills.

Trans has been and still is shifting fine for the moment. A couple months the flashing arrow on the dash came on and its driving me crazy. I cant stand a light on the dash much less a flashing one and the engine light came at the same time and neither can be cleared.

My cheap code reader pulled a solenoid B fault. Went and pulled a valve body and going to swap all 4 solenoids into mine. was going to just swap valve bodies but had a check valve ball fell out and I can't find where it goes.

I feel I'm driving a hurt transmission that can go at any time or go into limp home mode which takes off in 3rd gear. Driving like that it will overheat quickly in normal driving. So going to swap the solenoids for now and have me another transmission to have on standby for $150 as I don't trust what's in the car now. Had I known of the crud in what I installed it would never had happened. Bummer for me. For the 8 years I've been driving this 960 I just can't let her go for another trans swap. I've got way to much love that has gone into it, parts , money and time.

So if you've replaced the solenoids did it help and finally extinguish the flashing lights? I'll probably have to go to the shop and have all codes cleared as mine won't do it.

Edit, For the flashing light I've already tried 2 PNP switchs that I disassembled and cleaned before testing.

Thanks Dave
96-964
91'745

86-635CSi 215K



Previous- 83 245T, 84 242, 85 242T, 92 960, 94 960, 95-964, 95-945

User avatar
RickHaleParker
Posts: 3543
Joined: Mon May 25, 2015 2:30 pm
Year and Model: See Signature below.
Location: Kansas
Has thanked: 3 times
Been thanked: 429 times
United States of America
RickHaleParker

Re: "96 960- Anybody changed out the solenoids in the valve body

Post by RickHaleParker » Tue Jan 07, 2020 1:12 pm

dm635 wrote:
Tue Jan 07, 2020 11:46 am
I'll probably have to go to the shop and have all codes cleared as mine won't do it.
VOL-FCR 1.3 and a FTDI VAG cable will clear the transmission codes.

There is no way to get a copy of version 1.7 to work unless you pay £126.00 ($165.00) for it.

I would try this first. The flashing transmission light on my '97 S90 was just a communication cable. Fixed by cleaning the electrical connector and clearing the code with VOL-FCR 1.3.
Platform: P80 1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package, Plant: Uddevalla Sweden.

Platform: X40 (Nedcar) 2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. Plant: Born Netherlands.

Platform P2 2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0,
Plant Torslanda Sweden.
----------------------------------------------------------------
1997 S90, B6304S, AW30-42, Bosch Motronic 4.4 - Sold

Post Reply
  • Similar Topics
    Replies
    Views
    Last post