Financial Distress Parts Program

[matthew1]

^ too true

[gnalan]

I've posted in the junkyard request thread, in the classified's sub forum, for other parts that I need.

This is a great program, and it helped me a lot. I can't thank everyone enough for the parts, advice, and the support I received.

[liambean]

I recently changed the lug bolts on my 2001 (P2) V70 to lug studs and nuts. The Hex head is 19mm. The bolt length is 55mm from end to end. Please note that these were zinc coated, not chrome. There is some surface rust on the heads, and the bolts are a bit dirty with surface grease.
That means I have twenty (20) used (twenty years old) lug bolts that I can "donate" to this program. I'll mail them anywhere in the lower 48. Just let me know where.
Picture not representative of bolt state.

lug bolt.png (57.6 KiB) Viewed 22350 times

[liambean]

Since I changed the wheel mounts to studs and lug nuts, I no longer need the factory lug wrench / pry bar. The Hex end is 19mm. Though the car is 20 years old, I don't think this has ever been used as it looks brand new.

Lug Wrench Volvo Logo.jpg (227.54 KiB) Viewed 22304 times

Lug Wrench side view.jpg (294.67 KiB) Viewed 22304 times

[abscate]

I dispatched

2 front brake rotors
2 calipers
2 sets decent front brake pads
Pass headlight
SAS pump
Front radiator frame member
Cam sensor
Radiator
Rear number brackets

On the FDPP program to a car in progress

We thank all of you who donated parts and via donation to this program

[hipcheck]

Not sure if you just post here or not?

I’m not distressed from Covid or a layoff, however, I have recently wrecked my front end. I was able to find a donor for the passenger side fender, bumper, lower bumper cover, hood and grill. I also had to purchase a new radiator/AC condenser while at it. I do still need a decent set of headlights and corner/blinkers

I sent a few PM’s to people in the classifieds that had a set but they are offline I guess

If you have any used headlights ( I need the whole thing) and also the corners too.

Would prefer a matches set, but anything can get me back up and running and serve as spares later?

This is for a 1997 850 T-5 Wagon

Thank you,

Steve

[BigRed]

...

If you have any used headlights ( I need the whole thing) and also the corners too.

This is for a 1997 850 T-5 Wagon

Thank you,

Steve

I believe I have both headlamp assemblies and corners.

[hipcheck]

That would be a huge help. What could I do to set this up?

[abscate]

You guys can come to a mutual satisfying arrangement by private message or email , no need for third party meddling

BIg Red , thanks in advance - I hope that’s Cornell Big Red!

[Sufbug]

Little crazy, but I need intake manifold bolts the ones that are about 2.5 to 3 inches long. For a 98 v70 wagon GLT with the low pressure turbo. I need two of those bolts please. Message me and I will give you my address. Also, I can venmo a few dollars to cover postage / handling. THANK YOU!!! Allen aka Big Al