This car came to me with a partially disassembled motor, the PO had a water pump fail, timing belt... bent valves etc.
I have the motor all back together and am trying to get it started, but no fire yet.
I feel confident that I have the timing correct. I have fuel pressure at the fuel rail and have confirmed spark at one of the plugs. When I removed the plug it seemed to smell of gas (I wouldn't think all 5 injectors would be clogged...) The gas still smells like gas... but I did not drain the tank, and I have not added any new gas. I don't know how long the car was sitting, but my guess is this gas is 2-3 years old, and there is not much in the tank, likely making more likely to have absorbed a lot of water? So I think this is the next thing to try.
I do have a check engine light, hooked the car up to VIDA and reset codes, but still have a permanent failure with the following:
CEM - 1A5D Communication with ETM control module signal missing
CEM-DF13 CAN- H, high speed network
CEM-DF16 CAN- L, high speed network
ECM-2000 Engine cooland temperature (ECT) sensor - Signal too low
UEM- 0004 Siren Communication fault.
My sense is that these codes will clear (except probably the Siren...) once I get the car running. Anyone see any codes here that would indicate that I have other issues to deal with prior to moving on to the fuel? I did go back and double check to be sure I had all the connectors plugged in and grounds attached.
Thanks in advance for any input!
John
Get email notification of topic replies. Log in or register (free). Amazon Link Buy anything with this and it helps MVS!
Resurrecting a 2001 S60 T5 manual
-
- Similar Topics
- Replies
- Views
- Last post