Login Register

Engine rpm hovers around 1300 sometimes

Post Reply
icelandic
Posts: 158
Joined: 10 Jul 2007, 05:51
Year and Model:
Location: Sao Paulo- Brazil

Post by icelandic »

My 1994 850 NA has developed a tendency for idle to stay at 1300 rpms with my foot out of the pedal during decelleration. It happens ramdonly and when it happens i just press the pedal a bit and it immediatelly goes back to 800 rpms. TB is clean as well as the IAC.

What shoud I look for next? No codes, engine runs like a champ.
1995 859 auto NA

9394volvo850s
Posts: 239
Joined: 12 Oct 2009, 00:05
Year and Model: 93 850 5spd 94 850T5
Location: New York

Post by 9394volvo850s »

sounds like it could be in the linkage. check the rod that goes from the throttle cable wheel to the throttle body. it may need a bit of adjusting. its hard to diagnose problems when theres no codes.
93 850 5spd 320k (the daily)
94 850 T5 190K (race car)
95 T-5R wagon yellow (summer wag)
90 745 5spd 295k (winter wag)
67 122 2 door 4spd 69k :))

xb corp
Posts: 131
Joined: 19 Oct 2009, 20:02
Year and Model: 855GT5 '96
Location: Johor Bahru, Malaysia

Post by xb corp »

guys;
1. sticky accelerator assembly. start with pedal assembly > kick down switch area > cable route (make sure not twisted, clipped) > throttle drum.
2. broken/ leaked vacuum
3. throttle position sensor connector (dirt, oxidization)
4. dirty idle pump.
'96 855GT5 324hp 386lb-ft
Nissan 16V turbo, HKS w/g, SS 2.5" d/p+FGK 3" exh, HKS Evo9 FMIC+2.5" piping, K&N, Apexi BOV, NA cams & t/b, portd head, 5 sub-injctrs, Mocal coolers, AMG 4pot 325mm, AVS 18", Bilstein B6/Vogtland

tassieti
Posts: 7
Joined: 12 May 2009, 19:23
Year and Model: 1998 C70 HPT
Location: Tasmania, Australia

Post by tassieti »

That happens on my 94 850 T5 aswell sometimes. In my case it is because the clutch gap on my aircon compressor is too large and the computer thinks it is on and therefore raises the rpms to compensate for it but infact it isn't on.

icelandic
Posts: 158
Joined: 10 Jul 2007, 05:51
Year and Model:
Location: Sao Paulo- Brazil

Post by icelandic »

Thanks to allthet replied. I checked linkage this morning the problem was the rod with the two ball joints connecting the throttle cable wheel and the TB. It is actually adjustable (I didn´t now that). I took it out increased the lenght by approximately 1mm and all is ok now. Perhaps wear on the ball joints or on the TB became critical at that particular lenght and it just needed to be adjusted.

Thanks,

Icelandic
1995 859 auto NA

Post Reply
  • Similar Topics
    Replies
    Views
    Last post