Cyl head bolt/tap specs, 2001 s80,6cyl, 2.9L
Yes, I broke two of the cyl hd bolts. Getting ready to drill them out and want to be prepared with the tap. Specs pls ! Also, looked at the posted description of the timimg tool for holding the cams (mainly dimensions). Any dwgs available ?
-
dcarlson12
- Posts: 514
- Joined: 02 Jul 2008, 14:34
- Year and Model: 1997 850 T5
- Location: Surrey, BC, Canada
- Been thanked: 2 times
See two attached files re: torque.
Unfortunately I don't see any place where it gives the specs of the bolts.
Just measure one of the ones which didn't break with a thread gauge and/or micrometer or take to a machine shop and get them to measure for you or call an engine rebuilder or call a dealer and ask the service department manager....
Unfortunately I don't see any place where it gives the specs of the bolts.
Just measure one of the ones which didn't break with a thread gauge and/or micrometer or take to a machine shop and get them to measure for you or call an engine rebuilder or call a dealer and ask the service department manager....
- Attachments
-
tightening torque 2001 S80 T6.pdf- This is for T6. Not sure if yours is a turbo or naturally aspirated?
- (51.94 KiB) Downloaded 587 times
-
- Installing cylinder head 2001 S80.pdf
- This is for T6. Not sure if yours is a turbo or naturally aspirated?
- (446.69 KiB) Downloaded 1208 times
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4 Replies
- 1734 Views
-
Last post by petermetzger
-
- 2 Replies
- 1767 Views
-
Last post by Livens
-
- 5 Replies
- 17894 Views
-
Last post by beoutside
-
- 2 Replies
- 6579 Views
-
Last post by aksger
-
- 13 Replies
- 8473 Views
-
Last post by lifeofgold