Evap P0446 problem

Post by **polskamafia mjl** » 16 Aug 2010, 22:47

Hmm, where did you find that rollover valve? My evap leak came back too after I replaced the purge valve.

Post by **polskamafia mjl** » 17 Aug 2010, 16:29

May as well ad this link for future members who find this thread looking for answers:
-> http://volvospeed.com/vs_forum/index.ph ... ode-p0455/

yojaywuzup · Post by **yojaywuzup** » 18 Aug 2010, 16:39

I went to pull this line off and realized it is a two piece hose ( meaning it has a hard tube on the inside and a rubber tube on the outside which is what is cracked. Could this still be my issue or am I not looking in the right spot?

yojaywuzup · Post by **yojaywuzup** » 15 Nov 2010, 13:39

I've finally had a chance to revisit this problem and keep seeing references to the evap vent valve circuit. Is the vent valve the one inside the drivers side fender? I followed the shop manual procedure and even put voltage on the pruge valve to test it and it works. I am getting 6 volts at the purge valve, but am not sure if that is wht it should be seeing. Any advice would be greatly appreciated.

Thanks again,

Jay