My 2000 S80 recently went into limp mode, i read the codes and they reveal a ECM-902A, DTC is found not active. The local shop wants $1300 for replacement. Can i just pick up one of these units from the web and have them install it? Does it need to be re-programmed? Is it possible to just have mine re-built?
Thanks.
Eric.
Throttle Unit Communication Issues
-
kiteoregon
- Posts: 13
- Joined: 2 October 2011
- Year and Model: S80,2000
- Location: Oregon
-
precopster
- Posts: 7543
- Joined: 21 August 2010
- Year and Model: Lots
- Location: Melbourne Australia
- Has thanked: 8 times
- Been thanked: 128 times
This was a major design flaw and is covered under Volvo's 10 year warranty, however they will replace it with another (flawed one)
Call XeModex. They rebuild ETMs with a fully contactless design guaranteed to never fail again, well at least the sweep side of the ETM is warranted for life. Here's a link: http://xemodex.com/technologyimproved/a ... tle-module
Check this website and also have a read on this forum under Don's ETM Room: https://www.matthewsvolvosite.com/forums ... m.php?f=12
Call XeModex. They rebuild ETMs with a fully contactless design guaranteed to never fail again, well at least the sweep side of the ETM is warranted for life. Here's a link: http://xemodex.com/technologyimproved/a ... tle-module
Check this website and also have a read on this forum under Don's ETM Room: https://www.matthewsvolvosite.com/forums ... m.php?f=12
Current cars VW Transporter 2.5TDI, 2010 XC90 D5 R Design
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 1039 Views
-
Last post by Kolostealthtt
-
- 3 Replies
- 2162 Views
-
Last post by RickHaleParker