Is this a collapsed subframe bushing?

Post by **xHeart** » 01 Nov 2013, 10:32

I now have the tool Volvo press PN 9995457. It is big and heavy. Photo this weekend.
Any thoughts on four replacement bushing, OE/OEM?

Post by **xHeart** » 30 Dec 2013, 16:59

From steering gear replacement experience last winter, I am preparing to replace two rear subframe bushings.

: Volvo tool and bushing...; MVS_0991.jpg (626 KiB) Viewed 4331 times

Post by **xHeart** » 03 Jan 2014, 05:45

Photos of progress.
Visible wear and tear around each support pad, but it won't come apart tomorrow.
The subframe needs to come down another 18mm for the nipple/guide pin to clear (red arrow), and the counter-hold tool to fit above.

: visible wear and tear; MVS_1033.jpg (665.51 KiB) Viewed 4287 times

: nipple works like a guide pin; MVS_1031.jpg (761.47 KiB) Viewed 4287 times

Post by **xHeart** » 04 Jan 2014, 18:11

For cutting tool to work it takes 30mm socket. Below is a mock-up, it needs a deeper socket for the cutting sleeve to turn.

: cutting tool mock-up; MVS_1034.jpg (483.32 KiB) Viewed 4261 times

Post by **burnout8488** » 05 Jan 2014, 07:14

You really don't need that tool to do the job. Hammer a screwdriver into the bushing at various places and it will crack apart. You can then slide the screwdriver down the side of the bushing and pry it out.

Pressing new bushing in:

Just wedge something between the body and subframe, then draw the new mount in using the 18mm bolt and a socket wrench. The last few mm can be achieved with a hammer, the bushing will pop into position with a little grunt from a sledge.

I agree that your old bushing was toast - The "feet" on the bushing should always be in contact with the lower retaining plate.

Gompy58 · Post by **Gompy58** » 14 Oct 2024, 13:51

xHeart wrote: 30 Dec 2013, 16:59 From steering gear replacement experience last winter, I am preparing to replace two rear subframe bushings.
MVS_0991.jpg

Hi xHeart, sorry for kicking a long time ago post…

The thing is… I am really looking for the bushing tool 9995457….

Do you still have it or know anyway to get it ?

Check my signature, I can’t send any mail yet at this site :-/

Post by **Chuck W** » 14 Oct 2024, 18:58

You shouldn't need the tool to remove/install the subframe bushings.