00 S70 GLT All warning lights on

Post by **FLXC90** » 05 Oct 2014, 15:53

Pedal sensor problem for ETS Light on but ignored, car ran rich, sooted up your after-cat O2 sensor, (just changed mine, looked like a charcoal briquette) probably interconnected. ABS stuff all tied together with upshift arrow. Or could that be a Vehicle Speed Sensor issue?

Post by **rmmagow** » 05 Oct 2014, 16:22

Check that B+ cable and perhaps the Voltage regulator.

neworleans · Post by **neworleans** » 19 Oct 2014, 09:46

Sent the Module to Matt last week and got it back yesterday, installed it, when started only the check engine light came on along with the flashing arrow, a couple minutes later the arrow light went off. Scanned it and only showed P1618, tried to erase the code but no success. Did some research on the code, do you guys think I should take it to the dealer to have it erased?

Post by **abscate** » 21 Oct 2014, 19:07

Have you tried disconnecting the battery for 30 minutes to clear that last code?

Post by **rmmagow** » 21 Oct 2014, 19:16

You also might want to do as abscate says but while the battery is disco'd, remove the TCM (I think it should say ASIN someplace, check the pins/connections, maybe spray with electrical cleaner and reseat a couple of times to clean up maybe a dirty connection. You might want to do this with the ECU too while you're in there.

neworleans · Post by **neworleans** » 22 Oct 2014, 13:25

I will try that tonight, but i had it disconnected before removing the module and connected back again when installed back.

00 S70 GLT All warning lights on

Re: 00 S70 GLT All warning lights on