Login Register

1999 V70 XC Clicking sound from underneath

Post Reply
daveyboy8
Posts: 7
Joined: 24 Sep 2011, 11:28
Year and Model: 02 s60, 02 v70,00 v7
Location: United States(Michigan)

Post by daveyboy8 »

just updating post from this morning. checked out car and found "clicking" noise to be park brake cable against right rear tire. went thru slush this morning and then noise instantly started. couple of zipties for temp repair til next weekend. money stays in pocket at least for today.cable clip must have broke free and went against rear tire causing clicking noise.

PapaHepcat
Posts: 50
Joined: 31 Dec 2014, 18:52
Year and Model: v70 1999 XC
Location: Oregon - USA

Post by PapaHepcat »

daveyboy8 wrote:just updating post from this morning. checked out car and found "clicking" noise to be park brake cable against right rear tire. went thru slush this morning and then noise instantly started. couple of zipties for temp repair til next weekend. money stays in pocket at least for today.cable clip must have broke free and went against rear tire causing clicking noise.
Much cheaper and less work than a propshaft!
Current car:
1999 v70 xc Silver, 170k miles

Non Volvo cars:
1991 Ford F-350, 80k(180k?) miles
2004 Toyota Sienna, 124k miles

bastillecx
Posts: 1
Joined: 06 Mar 2010, 11:20
Year and Model: 1999 V70 XC AWD
Location: Sacramento

Post by bastillecx »

Hi all (and thank you for the many good comments),

My 1999 V70 XC wagon has just started the "clunking" routine, intermittent but can get quite loud. From below I was able to push up on the fwd portion of the "propeller" shaft - there was some play. I assume this means excessive wear inside the fwd joint/coupling.

I haven't seen replies to certain aspects of the problem (apologies if I overlooked them).

Questions:

1 Is it possible that only the fwd joint/coupling is bad? If yes, is it easily replaced (meaning not a pressed-on fit)?

2 Is it better to replace the entire shaft with a quality rebuild (coloradodriveshafts, etc)?

3 If replacing the entire shaft, is there anything else that should be replaced? Like the support bearing in the middle.

thanks in advance,
Chris

kahl
Posts: 943
Joined: 27 Oct 2012, 19:01
Year and Model: 2000V70XC
Location: columbus ohio
Been thanked: 10 times

Post by kahl »

Hi Chris, I just installed a Colorado driveshaft into my nephews 2000 V70 XC. It came with a new carrier bearing. I also put on a new crossmember P/N 9474483. I thought it was a great value. Straight forword remove and replace.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post