Replacing CVVT Solenoid for Code P1332

[sweet2burs]

hi I am getting ready to change my cvvt solenoid i ordered a used one on ebay of the exact match i did pull the part number before ordering to make sure and did look at the connector end .i have a 2002 volvo s80 will i need to have this programmed or can i simply just switch it out .since i will not have to cut any wires and also can i leave the battery hooked up again since i will only be unplugging this . i am asking this because the closest volvo dealership is over 2 hours from my location and no one in my area will touch a volvo ???? i need to know asap since my 89 gmc currently, i have had to remove my trany on that and wont have the replacement in for a bit

[allenzachary]

Disconnecting the battery is always the safest for you and the vehicle. But... I've changed these with the battery connected and never had an issue.

[MindOfVacuity]

Does anyone know what the bolts on the solenoid should be torqued to?

[abscate]

Torque 10 Nm crosswise

[Jmast755]

Hey is this applicable for a 1999 Volvo s80 T6? I have the same code coming up and I have emissions at the end of the month!

[Nicknice33]

I'm getting code p1332 and p0013 I just bought a camshaft positioning sensor is this all I need and will it work

[abscate]

Probably not the problem nick. Try replacing the CVVT, clearing codes, and see what comes back

[v-45magna]

Does anyone know if you can get just the wiring and female connector from Volvo? I've got a used one with the smaller connector to put on.

[v-45magna]

Can you get just the wire terminals and female connector/seals from anyone? Does anyone have an identifying number or name for this type of connector?

[abscate]

There was a good DIY on this and IM pretty sure the OP could not get the connector from Volvo - in fact he documented how to make sure you splice the right connectors into he OEM connector really well.