ETM Question

sebu06 · Post by **sebu06** » 24 Apr 2016, 04:23

Do I need a single from the CAN bus or the PWM signal from the accelerator, or could I simply connect the power source directly to the plug of the ETM?

Thanks for your support,
Sebastian

TonyatXeMODeX · Post by **TonyatXeMODeX** » 25 Apr 2016, 06:18

Yes you can run a power supply directly to the plug for the ETM. Make sure it is a switched power supply ( only activated when the ignition is in the second key position), then your CAN signal and PWM will still be active.

Regards,
Tony