2001 T6 ETM replaced but no luck
Replaced etm with xemodex but still has the same problem. Also replaced MAF. Will start, but surges and then stalls when put in drive. Same problem before xemodex replacement. Wondering if anybody had same issues and if so what could fix it. Thanks.
-
precopster
- Posts: 7543
- Joined: 21 Aug 2010, 00:20
- Year and Model: Lots
- Location: Melbourne Australia
- Has thanked: 8 times
- Been thanked: 128 times
When you sent XeModex a unit to rebuild, was it your own and suited the car?
They may just clone what you send them without a VIN check to see that the firmware is right for your particular vehicle.
With ignition on and no cranking does the ETM start up then turn off in under 8 seconds?
You really need a code reader and preferably a Dice to read your particular car; most other code readers can't see all the codes. A $450 XeModex diagnosis could have bought a fine scanner and some loose change.
They may just clone what you send them without a VIN check to see that the firmware is right for your particular vehicle.
With ignition on and no cranking does the ETM start up then turn off in under 8 seconds?
You really need a code reader and preferably a Dice to read your particular car; most other code readers can't see all the codes. A $450 XeModex diagnosis could have bought a fine scanner and some loose change.
Current cars VW Transporter 2.5TDI, 2010 XC90 D5 R Design
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 2128 Views
-
Last post by BrickBetty
-
- 8 Replies
- 4333 Views
-
Last post by donc
-
- 55 Replies
- 21688 Views
-
Last post by andrewgabler
-
- 9 Replies
- 2628 Views
-
Last post by Chuck W
-
- 27 Replies
- 6321 Views
-
Last post by xanthefin