My oil cooler lines did not leak, so I will reuse the ones for the oil.
For the Trans line I put one on and I can't seem to get the line back in, it's to tight.
I didn't want to force it and ruin the O ring, maybe it was the end of the day and my arms just didn't have the strength,
I don't know. This was the bottom line, as I think the top line is no good.
Also my top trans line, I went to wipe it clean, the insert with the O ring on it that goes into the rad , will spin right around freely as I hold the hose with my other had. All the other lines, trans + oil are solid. I'm thinking that the one that is spinning is toast and that was the leak .
I also got new clamps for the hoses, but by the time I get them over and behind the fitting, they are so spread out, is there a trick to it, or how do you put these on.
