Volvo #985186 bolt equivalent

Post by **theWIFES_S70** » 06 Dec 2016, 12:41

On some of our favorite part supplier websites, this bolt is listed as discontinued. Not to worry!!!

Volvo 985186 is equivalent to an 8mm x 1.25 x 20mm bolt.

: VOLVO_bolt_985186.jpg (67.25 KiB) Viewed 1487 times

Head sizes are different. (OE is 12mm and the DIN aftermarket bolt is 13mm.) Flanges are exactly the same size though. Only other difference is the Volvo bolt has a washer built into it.

beigg · Post by **beigg** » 06 Dec 2016, 15:12

both same tensile rating?

Post by **theWIFES_S70** » 06 Dec 2016, 16:45

Not sure. Can't read the markings on the OE Volvo bolt. But I would imagine 8.8 seems about right for this bolt.

The other bolt that holds up the rear muffler bracket read 8.8 on it.

This size does come in 10.9... https://www.boltdepot.com/Product-Detai ... duct=17744 but without the zinc-plated coating.

Post by **abscate** » 06 Dec 2016, 18:09

That's an application where the bolt rating isn't too important

Post by **abscate** » 14 Nov 2020, 05:41

Im not sure this info is correct here

The intake manifold flange bolts are M7 , not M8

If you have a 12 ratchet or gun, m8s will go in , but........

Very light torque on these, like 15 ft lbs. barely a nip on the 6 inch ratchet

Post by **RickHaleParker** » 14 Nov 2020, 06:35

abscate wrote: 14 Nov 2020, 05:41 Im not sure this info is correct here

The intake manifold flange bolts are M7 , not M8

The M8 is for bolting some lower brackets to the intake manifold.

Post by **scot850** » 14 Nov 2020, 12:01

Many of Volvo's bolts are rated at 8.8 grade. Unless you are being crazy this grade is good.

Neil.